Launching

After installing, YeOldeDink may be launched from the command line, or from a front-end such as Martridge or DFarc3. It may also be launched by double-clicking directly on the exe or AppImage in which case a box will pop up and allow you to choose several launch options such as full-screen or 24-bit mode. For AppImages, you may require xdialog or zenity installed to see the launch options.

The command line options are mostly the same as Freedink with a few exceptions:

• -w Launches in windowed mode rather than full-screen

• -d Start with debug mode on.

• -t Run in 24-bit 'truecolour' rather than a palette of 256. This should always be specified unless running something that requires palettes such as "Dink Goes Boating".

• -S Use the OpenGL renderer instead of the inbuilt SDL one. Note that this is a capital S.

• -nojoy Switch off joystick/controller input

• -nosound or -s Switches off audio output

• -g or -game specifies the path to a d-mod to launch with

• -r or --refdir specifies the path to Dink's main data location

• -c choose an alternate 'yedink.ini' config file path

• -7 v1.07 compatibility mode

• -h show help

For example, to start "The Quest for Cheese" in windowed 24-bit mode (not that anyone should ever do such a thing), one would type: yeoldedink.exe -w -t -g F:\qcheese

If you want to specify a custom refdir path, it must be the folder that contains "dink", rather than the path to "dink" itself. For example, on Windows >=7, assuming a standard install of freeware Dink 1.06, your refdir path would be C:\Program Files (x86)\Dink Smallwood\ without specifying "dink" at the end.

Be aware that when using AppImages on GNU/Linux you must specify the full path for refdir and game, rather than relative paths due to sandboxing constraints.